[M-bond 200] Vishay / 스트레인게이지 전용 상온용 접착제

스트레인 게이지용 본드 (Straingage Adhesive)

 

M-Bond 200 : 가장 널리 사용되는 일반- 목적의 접착제로 상온에서 빨리 굳어진다.

                    스트레인게이지 접착 상온용 접착제입니다.

 

 

Description

 For routine experimental stress analysis applications undertemperate

environmental conditions,

M-Bond 200 adhesive is ordinarily the best choice.

This adhesive is very easy to handle,

and cures almost instantly to produce an essentially creep-free,

fatigue-resistant bond, with elongation capability of five percent or more.

 

M-Bond 200 is a cyanoacrylate that has been pretested and

certified for use in bonding strain gages.

It is an excellent general-purpose adhesive for laboratory and

short-term field applications.

The procedure for making a strain gage installation with M-Bond 200 is illustrated

and described in detail in Instruction Bulletin B-127 included in

each kit of adhesive.

 

The user should note that the performance of the adhesive

can be degraded by the effects of time, humidity conditions,

elevated temperature, and moisture absorption.

Because of the latter effect,

strain gage installations should always be covered with a suitable protective coating.

When necessitated by more rigorous test requirements and/or environmental conditions,

consideration should be given to one of the M-Bond epoxy adhesives, using the

“Recommended Adhesives/Strain Gage Series” chart.

 

Characteristics Cure Requirements:
One-minute thumb pressure, followed by a minimum twominute
delay before tape removal. Bond strength increases
rapidly during first five minutes. Cure time must be
extended under conditions of low temperature (<70°F
[<21°C]) or low humidity (<40% RH).

Operating Temperature Range:
Short Term: –300° to +200°F [–185° to +95°C].

Long Term: –25° to +150°F [–32° to +65°C].

Elongation Capabilities:
>5% at +75°F [+24°C], 3% at +75°F [+24°C] when used
with CEA or EA/Option E strain gages.

 

Shelf Life:
3 months at +75°F [+24°C] after opening, with cap replaced
immediately after each use. Shelf life refers to the duration
of time, beginning on date of shipment, over which properly
stored adhesive should be expected to meet published
specifications.

Note: To ensure a proper seal, wipe bottle spout clean and
dry before replacing cap.
May be stored unopened up to 3 months at +75°F [+24°C]
or 6 months at +40°F [+5°C].

Note: Condensation rapidly degrades adhesive performance
and shelf life; after refrigeration, allow adhesive to
reach room-temperature before opening. Refrigeration after
opening is not recommended.

 

Packaging Options Kit:
1 bottle [1 oz/28 g] Adhesive
1 brush-cap bottle [30 ml] Catalyst
polyethylene dispenser cap

제품에 대한 문의사항은 네임카드를 참고해주시고

네임카드를 클릭하시면 홈페이지로 이동합니다.

감사합니다.